Heat Bed Power Expansion Board
An add-on module to extend the performance/protection of your control platine/mainboards.
Can be used on both Chitu motherboards and other open 3D printer motherboards. Works also with the Anet A8.
The current maximum of 15A of your PCB is increased. This add-on module increases the maximum current of your 3D printer motherboard up to 25A.
If you intend to use a heated bed with your 3D printer that uses a 12V or 24V power supply, this module is recommended because the excessive current can burn the connections on the interface board. It thus solves the problem of a heating bed current that is too large.
Specifications:
Maximum current: 25A (increased heat dissipation)
Size: 6 cm x 5 cm x 3,1 cm
Power supply: 12V & 24V
Note:
Please pay attention to the polarity of the connection cable before connecting.